Anycubic Air Filter for Kobra S1 / Kobra S1 Combo

SKU: S010271

Manufacturer: Anycubic

Compatibility: Anycubic Kobra S1, Anycubic Kobra S1 Combo

Filter type: activated carbon filter

Purpose: odor reduction and fine particle filtration inside the printer housing

Description

The Anycubic Air Filter for Kobra S1 and Kobra S1 Combo is a replacement filtering element for the enclosed housing of an FDM 3D printer. The filter is installed inside the printer and helps reduce odor while also filtering part of the fine particles that may appear during printing with different materials.

This part is especially useful for regular enclosed printing, long print jobs and materials with more noticeable odor. The filter does not replace proper room ventilation, but it helps make printer operation more comfortable and supports a cleaner internal housing environment.

Key Benefits

• Original Anycubic spare part for Kobra S1 and Kobra S1 Combo.
• Activated carbon filtering element.
• Helps reduce odor during printing.
• Supports fine particle filtration inside the printer housing.
• Installed inside the printer housing.
• Compact replacement part for regular filtration system maintenance.
• Suitable for replacing a worn or contaminated filter.

Technical Specifications

When Replacement May Be Needed

• Odor during printing becomes more noticeable than before.
• The filter looks dirty or darkened after long-term use.
• The printer is frequently used for long jobs inside an enclosed housing.
• Regular maintenance is being performed on Anycubic Kobra S1 or Kobra S1 Combo.
• The filtering element has been damaged, exposed to moisture or lost its shape.
• The filter needs replacement after extended printing with materials that produce stronger odor.

Installation and Use Recommendations

1. Turn off the 3D printer and disconnect the power cable before maintenance.
2. Wait until the chamber, hotend and heated bed cool down completely.
3. Open access to the filter installation area inside the printer housing.
4. Remove the old filter without excessive force.
5. Clean the mounting area from dust and contamination if needed.
6. Install the new air filter in the original position.
7. Make sure the filter is seated evenly and does not interfere with moving printer assemblies.
8. After replacement, power on the printer and check normal filtration system operation.

Important Note

The air filter helps reduce odor and capture some fine particles, but it does not make printing completely harmless and does not replace room ventilation. When printing ABS, ASA and other materials with stronger emissions, proper ventilation and safe operating practices are recommended.

Compatibility

The air filter with SKU S010271 is intended for Anycubic Kobra S1 and Anycubic Kobra S1 Combo. For Kobra Go, Kobra Neo, Kobra 2, Kobra 2 Neo, Kobra 2 Pro, Kobra 2 Plus, Kobra 2 Max, Kobra 3 and other models, compatibility should be checked separately by SKU, filter shape and housing design.

FAQ