Y-axis Synchronous Belt for Anycubic Kobra 2 Plus 1050 mm

SKU: S010177

Manufacturer: Anycubic

Compatibility: Anycubic Kobra 2 Plus

Purpose: Y-axis heated bed movement timing belt

Length: 1050 mm

Description

The Y-axis synchronous belt for Anycubic Kobra 2 Plus 1050 mm is a replacement spare part for the heated bed motion system of the FDM 3D printer. The belt controls the forward and backward movement of the print bed along the Y axis, so its condition directly affects print stability, model geometry, layer quality and positioning repeatability.

This part is suitable for repair, maintenance and preventive replacement on the Anycubic Kobra 2 Plus. Belt replacement may be required when the belt is stretched, worn, damaged, loose, causing backlash, layer shifting or uneven heated bed movement.

Important Naming Note

The product name may appear as Y axis synchronous belt (X timing Belt). For correct identification, use the SKU S010177, the model Anycubic Kobra 2 Plus, the 1050 mm length and the Y-axis application. Do not confuse this part with the X-axis belt for Kobra 2 Plus.

Key Benefits

• Compatible with the Anycubic Kobra 2 Plus 3D printer.
• Designed for the Y-axis movement assembly.
• Belt length — 1050 mm.
• Helps restore smooth heated bed movement.
• Suitable for repair, maintenance and preventive replacement.
• An important spare part for solving layer shifting, backlash and unstable print geometry.

Technical Specifications

When to Replace the Y-axis Belt

• Layer shifts appear in the Y-axis direction.
• The heated bed moves unevenly, with jerks or noticeable backlash.
• The belt is stretched and does not hold proper tension.
• Cracks, tooth wear, damage or deformation are visible on the belt.
• Clicking, slipping or vibration occurs during printing.
• The printer requires preventive maintenance after long-term operation.

Installation Recommendations

1. Turn off the 3D printer and disconnect the power cable before maintenance.
2. Loosen the Y-axis belt tensioner.
3. Remove the old belt carefully from the mounting points and guide rail.
4. Install the new belt along the original Y-axis routing path.
5. Make sure the toothed side of the belt correctly matches the pulley surface.
6. Secure the belt in the heated bed mounting points.
7. Adjust belt tension: it should be firm enough for accurate motion, but not overtightened.
8. After replacement, check bed movement, calibrate the position and perform auto-leveling.

Compatibility

The belt with SKU S010177 is intended for the Anycubic Kobra 2 Plus and the Y-axis movement assembly. For the X axis, Z axis and other Anycubic Kobra models, select separate belts according to the correct SKU, length and compatibility.

FAQ