GRAY Anycubic Water-Wash Resin+ is a professional resin for printing on photopolymer 3D printers, optimized for model formation from a weak LCD light source, while printing efficiency is higher than many existing DLP / LCD / SLA resins on the market.
Resin main features:
- water treatment;
- high accuracy;
- low odor
- low viscosity.
Anycubic Water-Wash Resin+ photopolymer resin provides high quality printing. The resin is based on a modernized formula to prevent cracking of models.
This resin provides strength to molded parts and avoids excessive shrinkage, as well as improving print speed, shortening curing time, and maximizing printing efficiency on LCD presses.
Anycubic Water-Wash Resin+ photopolymer resin provides not only high print efficiency and accuracy, but also minimizes resin release force and adhesion so that the model attached to the forming platform can be easily removed, and the low viscosity makes it easier to clean the machine and the model.
Photopolymer resin Anycubic (UV Resin) Basic - the material is hard and durable.
The characteristics of the model are stable: the resin is stable in various climatic conditions, and it is also easy to store, overcoming the shortcomings of other resins, which are easily softened when wet and corrode due to environmental influences.
Parameter Information:
Main material: resin monomer and photoinitiator
Exposure parameters: bottom exposure time (s) 15-40s, normal exposure time (s) 3-10s
Wavelength 365 - 405 nm
Density - 1.15 - 1.20 g/cm3
Viscosity - 150-250 MPa (at 25 degrees C)
Hardness - 80 Shore D
Tensile strength - 30-45 MPa
Elongation at break - 8-15%
Tensile modulus - 1600-1800 MPa
Bending strength - 50-60 MPa
Modulus of elasticity in bending - 1500-1600 MPa
Impact strength according to IZOD - 50-60 J/m
Storage method:
Store away from direct sunlight at room temperature (sunlight contains a lot of ultraviolet radiation, which causes the photosensitive resin to harden. After testing with light, it is not affected if it is not ultraviolet light). Sunlight contains a lot of ultraviolet light, which causes the photosensitive resin to harden.
It is recommended to keep at an ambient temperature of 15 ℃ -35 ℃, the lower the temperature, the higher the viscosity of the resin. Leaky storage, excessive dust or moisture can affect print quality.
Shake well before use, do not use the resin in places where there is a lot of sunlight.
Before use, put on gloves to avoid direct contact of the resin with the skin, and ensure the room is well ventilated.
In case of accidental contact of resin with skin, wash immediately with plenty of water. If you feel unwell, seek medical attention.
Do not pour resin from the resin tank into the unused resin without cleaning it, do not leave the resin in the resin tank for a long time without use, in order to avoid contamination of the resin affecting the printing effect (for a long time, the resin can be stored either in a sealed container or in a sealed polyethylene film tray for printing, keeping the shading).
The resin has a shelf life of up to 18 months.
